EasyManua.ls Logo

E.T. Systems Drive 300 - Contents

E.T. Systems Drive 300
50 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Introducon.
Page 3 Be Safe! Instrucons, warnings and obligaons.
Page 4 Technical specicaons.
Page 5 Component idencaon and operator dimensions.
Site preparaon.
Page 6 Gate preparaon and mechanical requirements.
Page 7 Duty cycle.
Page 7 Motor posioning.
Page 8 Cabling requirements.
Hardware installaon - Mechanical.
Page 9 Baseplate kit and installing the baseplate.
Page 10 Cable conduit height above baseplate.
Page 10 How to use the manual release override.
Page 11 Mounng the motor onto the baseplate.
Page 12 Installing the rack.
Hardware installaon - Electrical.
Page 14 Terminang the AC supply.
Page 15 Wiring and terminaon of the control card.
Page 16 Installing the limit actuator.
Control card programming and setup.
Page 17 Using the control card display and dashboard.
Page 18 Programming menu quick reference guide.
Page 19 Seng up the gate runme.
Page 20 Selecng a safety level.
Page 20 Safety infra-red beams setup.
Page 21 Selecng a BT operang mode and adjusng the BT auto-close me.
Page 22 Seng up the pedestrian open distance and pedestrian auto-close me.
Page 23 Receiver programming and setup.
Page 29 Switching the AC monitoring and/or built-in charger on or o.
Page 30 Adjusng the length of the slow speed at the ends of travel.
Page 30 Switching the posive close mode on or o.
Page 31 Selecng the Auxiliary relay’s mode of operaon.
Operang mode denions and examples.
Page 32 Collision sensing and safety overload rounes
Page 33 Safety infra-red beams funcon. All modes except P.I.R.A.C. auto-close mode.
Page 34 “BT” Buon triggers - Standard mode.
Page 35 “BT” Buon triggers - Simple auto-close mode.
Page 36 “BT” Buon triggers - Condominium auto-close mode.
Page 37 “BT” Buon triggers - P.I.R.A.C. auto-close mode.
Page 38 “PED” Pedestrian trigger. With no safety beams installed.
Page 39 “PED” Pedestrian trigger. With safety beams installed.
Page 40 Auxiliary relay modes - Strike lock mode.
Page 41 Auxiliary relay modes - Magnec lock mode.
Page 42 Auxiliary relay modes - Receiver relay mode.
Page 43 Auxiliary relay modes - Courtesy light mode.
Page 44 Auxiliary relay modes - Alarm mode.
Page 45 Posive close mode.
Page 46 Holiday lock-out mode.
Page 47 Auto-close override/party mode.
Troubleshoong.
Page 48 Status LED, buzzer and diagnoscs menu denions.
Page 49 Troubleshoong guide and display denions.
Page 50 Warranty.

Table of Contents

Related product manuals