E.T. Systems Drive 300 - Simple Auto-Close Mode BT Trigger Functions

35
User manual reference -
Page 10
“BT” Buon triggers.
Simple auto-close mode.
Basic operang
features
The BT funcons are the primary full gate opening funcons for motor vehicle access.
There are two ways of acvang the “BT” funcons on this control card. Either via the hardwired BT input or the BT receiver channel.
Simple auto-close mode funcons exactly the same as standard mode except that the gates will close automacally aer the programmed BT
auto-close mer has med out.
In this mode you have access to the following advanced features: - Holiday lock-out and Party mode.
NB! For any auto-close feature to work, a pair of safety infra-red beams must be installed and funconing correctly.
Acon Response
Momentary BT trigger.
Gate begins
opening.
No buzzer tones.
At full open posion. Gate stops. No buzzer tones.
Momentary BT trigger
or auto-close mer
meout. Safety beam
input not triggered.
Gate begins
closing.
No buzzer tones.
Momentary BT trigger.
Gate stops and
immediately
starts opening
again.
No buzzer tones.
Momentary BT trigger. Gate stops. No buzzer tones.
Momentary BT trigger
or auto-close mer
meout. Safety beam
input not triggered.
Gate begins
closing.
No buzzer tones.
At full closed posion. Gate stops. No buzzer tones.
0
20 sec.
STOP
0
20 sec.