1
2
3
1
2
• Remove brake cable set nut to rear end.
• Adjust the adjusting nut to loosening position
and fix the groove across the brake drum.
• Remove brake cable adjusting bolt .
• Loosen set nuts on left and right motor and
frame as illustrated.
• Remove motor three-phase circuit and Hall
connector as illustrated.
• Pull the three-phase circuit and Hall connector
across frame gap.
• Remove the motor.
When failed, the precise circuits and electronic
component in the motor must be replaced or
repaired by the authorized dealer immediately
by the rider to insure riding safety.
and are forbidden to be removed and decomposed
To Next Page
Loading...
