MF2E-E -B 2
- 25 -
- To make the camera zoom close
Near Near the camera focus
Far F ar from the camera to focus on
Stop Stop PZT control
Notice:
Notice:
Notice:
Notice: Hold
Hold
Hold
Hold down
down
down
down the
the
the
the mouse
mouse
mouse
mouse over
over
over
over the
the
the
the operation,
operation,
operation,
operation, the
the
the
the operation
operation
operation
operation should
should
should
should be
be
be
be carried
carried
carried
carried out
out
out
out
relative,when
relative,when
relative,when
relative,when the
the
the
the release
release
release
release of
of
of
of the
the
the
the mouse,the
mouse,the
mouse,the
mouse,the operation
operation
operation
operation will
will
will
will be
be
be
be stopped
stopped
stopped
stopped relative.
relative.
relative.
relative.
4. Preset
Set ： Set the current PZT positon as the preparative position
Clear ： Clear current PTZ preparative position
Go ： Start cruise
Start ： Start Point of cruise
End ： End Point of cruise
Auto ： Open or close the function of auto cruise
5. GPIO Control
Button control GPIO GPIO port level, green low, red high, brown says unknown
The button corresponding GPIO port settings, see the menu [System -> Options -> GPIO
Config]
6. Audio & Video Control
Resolution ： Adjust the revolution of the camera
Brightness ： Adjust the brightless of the camera
Contrast ： Adjust the contrast of the camera
Saturation ： Adjust the saturation of the camera
Hue ： Adjust the hue of the camera
Volume ： Adjust the volume of the camera
Camera Mode ： Adjust the motion jpeg ipcam
’
s camera mode.[in door/out door]
7. Record
Video features the main interface, the main interface, including video button [Start Video],
[Stop recording], [state] [Browse] and right menu [video] items.
[Start Video]: Click to start recording, will start recording all current windows.
[Stop recording]: Click to stop recording, all windows will stop the current video.
[Status]: Click the status button, will pop the current video information display form.
To Next Page
Loading...
