INSTALLATION
Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide S 164201449 Rev B www.eaton.com/powerquality
25
4. Connect the internal battery connector (see Figure 4).
NOTE A small amount of arcing may occur when connecting the batteries. This is normal
and does not damage the unit or present any safety concern.
Figure 4. Connecting the Internal Battery Connector
5. Replace the UPS front cover (see Figure 5).
Figure 5. Replacing the UPS Front Cover
6. Continue to the following section, “UPS Setup.”
UPS Setup
The Eaton 5115 RM UPS is designed for flexible configurations and can
be installed in a rack, on a wall, or as a standalone cabinet. Set up the
UPS according to the type of installation:
S “Mounting the UPS in a 19” Rack” on the following page.
S “Mounting the UPS in a 23” Rack” on page 29.
S “Zero-U Mounting” on page 30.
S “Wall-Mount Setup” on page 32.
If you are using the UPS as a standalone cabinet, continue to “Installing
the UPS” on page 33.
To Next Page
Loading...
