INSTALLATION
Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide S 164201449 Rev B www.eaton.com/powerquality
26
Mounting the UPS in a 19” Rack
To install the UPS in a 19” rack configuration using the supplied
hardware:
1. Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
2. On each side of the UPS, attach the long end of a mounting bracket
to the UPS using four of the M3
6 screws (see Figure 6).
Mounting Bracket
M3 6 Bracket Screws
Figure 6. Mounting Bracket for a 19” Rack
3. Loosen the assembly wing nuts on both rail assemblies and adjust
the rail size for the depth of your rack (see Figure 7).
4. Position the rear hold-down bracket toward the end of the rail
assemblies where the end of the UPS will be located and tighten
the wing nut.
Front
Rear
Assembly
Wing Nuts
Rail Assembly
Wing Nut for Rear
Hold-Down Bracket
Rear Hold-Down Bracket
Figure 7. Adjusting the Rail Depth
To Next Page
Loading...
