INSTALLATION
Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide S 164201449 Rev B www.eaton.com/powerquality
24
Connecting the UPS Internal Battery
To ensure proper battery operation before installing the UPS:
1. Verify that the UPS is off and unplugged.
2. Pull the right side of the UPS front cover to release the snaps at the
right and middle of the cover (see Figure 2). Remove the UPS front
cover from the left side.
Figure 2. Removing the UPS Front Cover
3. Remove the protective label from the internal battery connector
(see Figure 3).
Figure 3. Removing the Protective Label
To Next Page
Loading...
