Eaton 5115 User Manual

INSTALLATION
Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide S 164201449 Rev B www.eaton.com/powerquality
30
Zero-U Mounting
To install the UPS in a zero-U rack configuration using the supplied
hardware:
1. Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
2. Attach four mounting brackets to the UPS as shown in Figure 13.
Secure the short end of the mounting bracket to the UPS using two
of the supplied M3
6 screws.
3. Adjust the sides of the rack to fit the UPS and brackets (within
56.35–56.95 cm or 22.54–22.78”).
4. Secure the UPS to the side of the rack cabinet using one M6
10
screw and one clip nut in each mounting bracket.

Eaton 5115 Specifications

General

Form Factor	Tower
User-selectable Output Voltage	No
Frequency	50/60 Hz
Topology	Line Interactive
Communication Ports	Serial, USB
Output Frequency	50/60 Hz
Input Frequency	50/60 Hz
Battery Type	Sealed, lead-acid
Typical Recharge Time	8 hours
Operating Temperature	0 to 40°C
Storage Temperature	-15 to 45°C
Humidity	0% to 95% relative humidity, non-condensing