INSTALLATION
Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide S 164201449 Rev B www.eaton.com/powerquality
29
Mounting the UPS in a 23” Rack
To install the UPS in a 23” rack configuration using the supplied
hardware:
1. Place the UPS on a flat, stable surface with the front of the UPS
facing toward you.
2. On each side of the UPS, attach the short end of a mounting
bracket to the UPS using two of the M3
6 screws (see
Figure 11).
Rack Tray
Mounting Bracket
M3 6
Bracket
Screws
Figure 11. Rack Tray and Mounting Bracket for a 23” Rack
NOTE Rails cannot be used for 23” cabinets. Confirm that you have a rack tray.
3. Slide the rack tray into the rack and slide the UPS onto the tray.
4. Secure the front of the UPS to the rack using the supplied hardware
(two M6
10 screws and two clip nuts on each side, as shown in
Figure 12).
Figure 12. Securing the UPS in a 23” Rack
To Next Page
Loading...
