OPERATION
Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide S 164201449 Rev B www.eaton.com/powerquality
37
UPS Front Panel
The UPS front panel indicates the UPS status and also identifies
potential power problems. Figure 17 shows the UPS front panel
indicators and controls.
On/Off Button
Test/Alarm Reset Button
Power On Indicator (green)
On Battery Indicator (yellow) Overload Indicator (red)
Service Indicator (red)
Load Segment 2 Indicator (green)
Load Segment 1 Indicator (yellow)
Figure 17. UPS Front Panel
If the alarm beeps or a UPS alarm indicator stays on, see Table 8 on
page 58 to identify and correct the problem.
Initiating the Self‐Test
NOTE The batteries must be fully charged and the UPS must not be in Battery mode to
perform the self‐test.
Press and hold the button for three seconds to initiate the self‐test.
If the alarm beeps or a UPS alarm indicator stays on, see Table 8 on
page 58.
To Next Page
Loading...
