Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide S 164201449 Rev B www.eaton.com/powerquality
1
Chapter 1 Introduction
The Eaton
®
5115 Rack-Mount (RM) uninterruptible power system (UPS)
is a high-density power protection solution ideal for servers, storage
systems, network equipment, and other critical devices.
The slim design and wide range of installation possibilities make the
Eaton 5115 RM the most versatile UPS available. With only 1U (1.75”) of
rack-height, the UPS can be installed in rack-mount, wall-mount,
side-mount (zero-U), and bench-top applications.
Providing a true sine wave output, the UPS delivers smooth, continuous
power during normal and battery operation. In addition, the UPS corrects
incoming voltage fluctuations to further protect the connected
equipment from power problems such as power sags and surges.
Figure 1. The Eaton 5115 RM UPS
Providing outstanding performance and reliability, the Eaton 5115 RM's
unique benefits include the following:
S 1U rack height that conserves valuable rack space.
S Buck and Boost voltage regulation that ensures consistent voltage to
your load by correcting voltage fluctuations.
S ABM
®
technology that uses advanced battery management to
increase battery service life, optimize recharge time, and provide a
warning before the end of useful battery life.
S Start‐on‐battery capability for powering up the UPS even if utility
power is not available.
S Hot‐swappable batteries that simplify maintenance by allowing you to
replace batteries safely without powering down the critical load.
S Optional X-Slot
®
cards with enhanced communication capabilities for
increased power protection and control.
To Next Page
Loading...
