Eaton FX6000 - Print; Lamp Test

76 FX6000 INSTALLATION AND OPERATION MANUAL 25-14683-C December 2019 www.eaton.com
Panel controls & indicators
Print
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and
enter the passcode.
1. Enter the Supervisor Mode and Select the “Others” Tab. Press “Print”.
2. Select the Information You wish to Print from the Buttons Listed.
Lamp test
To activate the touch screen, touch the top left corner of the screen until the screen
illuminates. To enter the supervisor mode touch the supervisor button and
enter the passcode.
1. Enter the Supervisor Mode and Select the “Others” Tab.
2. Press “Lamp Test”.
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Supervisor
FRE off
Others
View Fires
AC = 19
View Pre
Alarms
View
Disabled
View
Faults
Weekly Test
Enable/Disable
View Log
Check
Auto Config.
Lamp test
Print
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Supervisor
FRE off
Print Current Fires
Exit
Print Last 10 Log Records
Print Test Log
Print Disablements
Print Current Faults
Print All Log Records
Print Fire Log
Print Fault Log
Evacuate
Silence
Alarms
Mute
Buzzer
Reset
Others
Print
View Fires
AC = 19
View Pre
Alarms
View
Disabled
View
Faults
Weekly Test
Enable/Disable
View Log
Check Config.
Lamp Test
Supervisor
FRE off
Supervisor
FRE off
Lamp Test
LED’s will light in
numerical order
Ok
Cancel