1
INTRODUCTION
Thank you for purchasing this compact, high performance, air-cooled, 
engine-driven generator. It is designed to automatically supply electrical 
power to operate critical loads during a utility power failure.
This unit is factory installed in an all-weather, metal enclosure and is 
intended exclusively for outdoor installation. This generator will operate 
using either vapor withdrawn liquid propane (LP) or natural gas (NG).
NOTE:
This generator is suitable for supplying typical residential loads such 
as Induction Motors (sump pumps, refrigerators, air conditioners, 
furnaces, etc.), Electronic Components (computer, monitor, TV, etc.), 
Lighting Loads and Microwaves.
READ THIS MANUAL THOROUGHLY
If any portion of this manual is not understood, contact the nearest Dealer 
for starting, operating and servicing procedures.
SAFETY RULES
Throughout this publication, and on tags and decals affixed to the genera-
tor, DANGER, WARNING, CAUTION and NOTE blocks are used to alert 
personnel to special instructions about a particular operation that may be 
hazardous if performed incorrectly or carelessly. Observe them carefully. 
Their definitions are as follows:
INDICATES A HAZARDOUS SITUATION OR ACTION WHICH, IF 
NOT AVOIDED, WILL RESULT IN DEATH OR SERIOUS INJURY.
Indicates a hazardous situation or action which, if not 
avoided, could result in death or serious injury.
Indicates a hazardous situation or action which, if not 
avoided, could result in minor or moderate injury.
NOTE:
Notes contain additional information important to a procedure 
and will be found within the regular text body of this manual.
These safety warnings cannot eliminate the hazards that they 
indicate. Common sense and strict compliance with the special 
instructions while performing the action or service are essential to 
preventing accidents.
Four commonly used safety symbols accompany the DANGER, 
WARNING and CAUTION blocks. The type of information each 
indicates is as follows:
 This symbol points out important safety information that, 
if not followed, could endanger personal safety and/or 
property of others.
This symbol points out potential explosion hazard.
This symbol points out potential fire hazard.
This symbol points out potential electrical shock hazard.
The operator is responsible for proper and safe use of the equipment. The 
manufacturer strongly recommends that the operator read this Owner's 
Manual and thoroughly understand all instructions before using this 
equipment. The manufacturer also strongly recommends instructing other 
users to properly start and operate the unit. This prepares them if they 
need to operate the equipment in an emergency.
CONTENTS
This manual contains pertinent owner’s information for these models:
•  7 kW NG, 8 kW LP, single-cylinder GH-410 Engine
•  9 kW NG, 10 kW LP, V-twin GT-530 Engine
•  13 kW NG, 14 kW LP, V-twin GT-990 Engine
•  16 kW NG, 17 kW LP, V-twin GT-990 Engine
•  18 kW NG, 20 kW LP, V-twin GT-999 Engine
OPERATION AND MAINTENANCE
It is the operator's responsibility to perform all safety checks, to make sure 
that all maintenance for safe operation is performed promptly, and to have 
the equipment checked periodically by a Dealer. Normal maintenance ser-
vice and replacement of parts are the responsibility of the owner/operator 
and, as such, are not considered defects in materials or workmanship 
within the terms of the warranty. Individual operating habits and usage 
contribute to the need for maintenance service.
Proper maintenance and care of the generator ensures a minimum number 
of problems and keep operating expenses at a minimum. See a Dealer for 
service aids and accessories.
HOW TO OBTAIN SERVICE
When the generator requires servicing or repairs, contact a Dealer for 
assistance. Service technicians are factory-trained and are capable of 
handling all service needs.
When contacting a Dealer about parts and service, always supply the 
complete model number and serial number of the unit as given on its data 
decal, which is located on the generator. See section "The Generator" for 
decal location.
Model No.  _________________  Serial No. ______________
Safety Rules
Data Label Sample