Eaton i-on16 Installation Guide

i-on16
Page iii
Contents
1. Introduction ....................................................... 1
Overview ............................................................. 1
Installer Programming Interface ..................... 1
About this Guide ............................................ 1
2. Before You Begin .............................................. 2
Preparation ......................................................... 2
Radio Site Survey .......................................... 2
Siting the Control Unit .................................... 2
Siting Keypads ............................................... 2
Guided Tour ........................................................ 2
Opening the End Station Case ...................... 2
End Station PCB ............................................ 3
Keypads ......................................................... 3
Power Availability ............................................... 6
Keypad Cabling Requirements ........................... 7
3. Installation ......................................................... 8
Tools Required ................................................... 8
Step 1. Fit the Control Unit Box .......................... 8
Fitting ............................................................. 8
Step 2. Fit and Connect the Keypad(s) .............. 8
Siting the Keypad(s) ....................................... 9
Fitting Keypads .............................................. 9
Connecting Keypads to Control Unit .............. 9
Keypad Connection ........................................ 9
Keypad Addressing ...................................... 10
Re-using a V2.0 Keypad From an i-onEX .... 10
Backlight Control i-kp01 ............................... 10
Backlight Control for KEY-K01/KP01/KPZ01 10
Tone Volume – All Keypads......................... 13
Connecting Wired Zones (KEY-KPZ01 only) 13
Step 3. Connect End Station to Mains ............. 13
Mains Cabling .............................................. 13
Mains Connection ........................................ 14
Step 4. Connect Wired Peripherals .................. 14
Remote Loudspeaker (Optional) .................. 14
Wired External Sounders (Optional) ............ 14
Wired Outputs (Optional) ............................. 14
Fit and connect the I-RC01 (Optional) ......... 14
Output on KEY-KPZ01 ................................. 15
Step 5. Fit and Connect I-SD01 (Optional) ...... 15
Safety Notice ................................................ 15
Removing an I-SD01 .................................... 16
Step 6. Fit and Connect Battery ....................... 16
Programming a Control Unit Before Installation
..................................................................... 16
Step 7. Initial Power-Up .................................... 16
Step 8. Commission the System ...................... 17
4. Programming .................................................. 18
Re-Entering the Installer Menu .................... 18
Leaving the Installer Menu ........................... 18
Important! Saving Changes .............................. 18
Restoring the Access Codes (1
st
stage Reset) 18
Restoring All Factory Default Programming ..... 19
Learning radio detectors ................................... 19
Installer Menu ................................................... 20
5. Maintenance .................................................... 21
6. Technical Specification .................................. 22
Specification ..................................................... 22
General ........................................................ 22
Security ........................................................ 22
Radio ............................................................ 22
Communications .......................................... 22
Power Supply ............................................... 22
Electromagnetic Compatibility ...................... 23
Outputs ......................................................... 23
Fuses ........................................................... 23
Electrical Safety ........................................... 23
Compliance Statements ............................... 23
Compatible Equipment ..................................... 23
HUD ............................................................. 23
Detectors ...................................................... 23
Sounders ...................................................... 23
Setting / Unsetting – Keypads ...................... 23
Setting / Unsetting - Fobs ............................ 23
Communicators ............................................ 23
Accessories .................................................. 23
Appendix I. Recording Speech Messages ....... 24

Eaton i-on16 Specifications

General

Brand	Eaton
Model	i-on16
Category	Security System
Language	English