Eaton Powerware 9125 - Connecting the UPS Internal Battery

INSTALLATION
EATON Powerware
®
9125 Two-in-One UPS (700–2000 VA) User’s Guide S 164201514 Rev B www.powerware.com
20
Connecting the UPS Internal Battery
To ensure proper battery operation:
1. Verify that the UPS is off and unplugged.
2. Remove the UPS front cover (see Figure 2).
Figure 2. Removing the UPS Front Cover
3. Connect the internal battery connector (see Figure 3).
Figure 3. Connecting the Internal Battery Connector
4. Replace the UPS front cover (see Figure 4).
Figure 4. Replacing the UPS Front Cover
5. Continue to the following section, “UPS Setup.”