INSTALLATION
EATON Powerware
®
9125 Two-in-One UPS (700–2000 VA) User’s Guide S 164201514 Rev B www.powerware.com
25
Installing the UPS
NOTE Do not make unauthorized changes to the UPS or accessories; otherwise, damage
may occur to your equipment and void your warranty.
Figure 11 shows a typical installation only. See “UPS Rear Panels” on
page 29 for the rear panel of each model.
To install the UPS and optional EBMs:
1. If installing an optional EBM, continue to Step 2; otherwise, skip to
Step 3.
2. Plug the EBM cable(s) into the battery connector(s) as shown in
Figure 11. Up to four EBMs may be connected to the UPS.
UPS Battery
Connector
Power Cord
EBM Cable
Output Receptacles
Communication Port
UPS
EBM
EBM
EBM Battery Connectors
Figure 11. Typical UPS Installation with Two EBMs
3. If you are installing power management software, connect your
computer to the UPS communication port using the supplied
communication cable.
4. Plug the equipment to be protected into the appropriate UPS output
receptacles (see page 46 for more information on load segments).
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
To Next Page
Loading...
