Eaton Powerware 9125 - USB Card

ADDITIONAL UPS FEATURES
EATON Powerware
®
9125 Two-in-One UPS (700–2000 VA) User’s Guide S 164201514 Rev B www.powerware.com
44
On-Bypass Relay Jumper
(J3)
On-Bypass
Disabled
On-Bypass
Enabled
AS/400NORM
Figure 25. On-Bypass Relay Jumper
3. To prevent electrostatic discharge (ESD), place one hand on a metal
surface such as the UPS rear panel.
Align the Single-Port Card with the slot guides and slide the card
into the slot until it is firmly seated.
4. Secure the Single-Port Card with the screws removed in Step 1.
USB Card
With this card, the UPS can communicate with a USB-compliant
computer using Powerware LanSafe Power Management Software
(v5.0.1 or higher).
To establish communication between the UPS and a computer:
1. Connect the USB cable to the USB port on your computer.
2. Install the Powerware LanSafe software and USB drivers according
to the instructions provided with the Software Suite CD.