INSTALLATION
Eaton 9135 Two-in-One UPS (5000/6000 VA) User's Guide S 164201726 Rev 3 www.eaton.com/powerquality
23
UPS Setup
The Eaton 9135 UPS is designed for flexible configurations and can be
installed in a rack or as a standalone cabinet.
If you are installing the UPS in a rack, continue to the following section,
“Rackmount Setup;” otherwise, continue to “Tower Setup” on page 30.
Rackmount Setup
The rail kit can be mounted in 19‐inch panel (48 cm) racks from 24 to
30 inches (61 to 76 cm) deep and includes:
S Left and right sliding rail assemblies
S (20) M4 6 mm Phillips
®
flat-head screws
S (4) M4 10 mm Phillips round-head screws
S (4) M6 12 mm Phillips round-head screws
S (8) M6 12 mm Phillips flat-head screws
S (2) mounting brackets
S (2) rear hold-down brackets
To Next Page
Loading...
