INSTALLATION
Eaton 9135 Two-in-One UPS (5000/6000 VA) User's Guide S 164201726 Rev 3 www.eaton.com/powerquality
24
Installing the Rail Kit
C A U T I O N
S DO NOT install the UPS or EBM in a hermetically-closed environment without any
exchange of air.
S The UPS and EBM are heavy (see page 67): 1) Eaton strongly recommends to remove the
battery tray from the UPS before lifting. 2) A minimum of two people are required to lift
the cabinets into the rack.
NOTE The rails and the necessary mounting hardware are supplied by Eaton.
To install the rail kit:
1. Adjust the UPS control panel orientation by slightly pulling out the
control panel and rotating it 90° counterclockwise (see Figure 4).
Figure 4. Adjusting the UPS Control Panel Orientation
To Next Page
Loading...
