ADDITIONAL UPS FEATURES
Eaton 9135 Two-in-One UPS (5000/6000 VA) User's Guide S 164201726 Rev 3 www.eaton.com/powerquality
58
USB Port
The UPS can communicate with a USB-compliant computer using
LanSafe
®
Power Management Software or other HID-compliant power
management software compatible with Microsoft
®
Windows
®
2000 and
XP operating systems that support HID devices.
NOTE The latest versions of the LanSafe Power Management Software and the USB
firmware are available at www.eaton.com/powerquality
To establish communication between the UPS and a computer:
1. The USB port is hot-pluggable. Connect the USB cable to the USB
port on the UPS rear panel (see Figure 35).
Connect the other end of the USB cable to the USB port on your
computer.
USB Port
Figure 35. The USB Port
2. Install the LanSafe Power Management Software and USB drivers
according to the instructions provided at
www.eaton.com/powerquality.
To Next Page
Loading...
