OPERATION
Eaton 9135 Two-in-One UPS (5000/6000 VA) User's Guide S 164201726 Rev 3 www.eaton.com/powerquality
49
Turning the UPS Off
To shut down the UPS:
1. Press the
button for approximately three seconds.
The UPS beeps once, and the load is no longer protected by the
UPS. It is powered by utility power. If the UPS is set in frequency
converter mode, the equipment will not be powered.
If the utility power is out of tolerance, the UPS will generate a
10 ms output calibrated break.
2. For a full shutdown of UPS and connected load, the upstream
circuit breaker (not included) should be set to the OFF position.
Operating Modes
The Eaton 9135 front panel indicates the UPS status through the UPS
indicators. Figure 30 shows the UPS front panel indicators and controls.
Power On Indicator
On Battery Indicator
Bypass Indicator
Alarm Indicator
On/Off Button
Lit
Flashing
Unlit
Indicator Legend
Figure 30. UPS Front Panel
To Next Page
Loading...
