Eaton Powerware 9135 - Operating Modes

INSTALLATION
Eaton 9135 Two-in-One UPS (5000/6000 VA) User's Guide S 164201726 Rev 3 www.eaton.com/powerquality
43
Output Terminal
Input Terminal
GND L2
(N)
L1
GND L2
(N)
L1
Figure 25. Installing the Input and Output Cables (U Models)
5. Replace the terminal block cover and tighten the cables.
6. Secure the terminal block cover with the two screws removed in
Step 1.
7. Plug the equipment to be protected into the appropriate UPS output
receptacles.
NOTE If more than one load is connected to the UPS, the total capacity of the loads should
not exceed 30A.
2
00
−−
25
0V~,
2
4
A
RY
B
A
T
TE
C
O
N
N
E
C
T
O
1
80
Figure 26. Connecting the Power Cords (U Models)