Eaton PowerXL DG1-323D7FB-C21C - Rubber Grommet Installation Instructions

Chapter 6—Installation Requirements
32 DG1 Series VFD MN040002EN—March 2014 www.eaton.com
Rubber Grommet Installation Instructions
Step 1: Measure the outside diameter of the cable (D1)
used to connect to the drive.
Step 2: Measure the outside diameter of the
rubber grommet (D2) and select a suitable
D2 (D1 ≤ D2 ≤ D1 + 2 mm).
Step 3: Cut the rubber grommet at the selected diameter.
Step 4: Run the cable through the rubber grommet.
Step 5: Insert the rubber grommet into the conduit plate
together with the cable.
Step 6: Fasten the rubber grommet and cable with a
self-locking cable tie.
D1 (Cable)
D2 (Grommet)
D1 ≤ D2 ≤ D1 + 2 mm
Self-Locking Cable Ties