Class A EMC Statements
FCC Part 15
NOTE This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
ICES-003
This Class A Interference Causing Equipment meets all requirements of the Canadian Interference Causing
Equipment Regulations ICES-003.
Cet appareil numérique de la classe A respect et outes les exigences du Reglement sur le matériel brouilleur
du Canada.
Requesting a Declaration of Conformity
Units that are labeled with aCE mark comply with the following harmonized standards and EU directives:
The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC
Declaration of Conformity, contact:
Eaton Power Quality Oy
Koskelontie 13
FIN-02920 Espoo
Finland
Phone: +358-9-452 661
Fax: +358-9-452 665 68
l
Harmonized
Standards:
IEC 61000-3-12
l
EU Directives: 73/23/EEC, Council Directive on equipment designed for use within certain
voltage limits
93/68/EEC, Amending Directive 73/23/EEC
89/336/EEC, Council Directive relating to electromagnetic compatibility
92/31/EEC, Amending Directive 89/336/EEC relating to EMC
Eaton, Powerware, Cutler-Hammer, PowerXpert, and X-Slot are registered trademarks of Eaton Corporation or
its subsidiaries and affiliates. Hyper Terminal is a registered trademark of Hilgraeve. Modbus is a registered
trademark of Schneider Automation. National Electrical Code and NEC are registered trademarks of National
Fire Protection Association, Inc. Phillips is a registered trademark of the Phillips Screw Company. All other
trademarks are property of their respective companies.
Copyright20102019 Eaton Corporation, Raleigh, NC, USA. All rights reserved. No part of this document
may be reproduced in any way without the express written approval of Eaton Corporation.
To Next Page
Loading...
Need help?
General
