Eaton SC100 - SC100 Operation using the Keypad and Screen; Voltage Control

SC100 Handbook
8
Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
SC100 Operation using the Keypad and Screen
Navigation
Symbol
Function
 Move up/down to previous/next screen.
 Move up/down in a list (hold to go to the top or bottom of the
list).
 Highlight options in a screen.
 Increase/decrease a value in a configuration screen.
 Use either up/down key to scroll
 Go to Main Menu screen
 Perform the action shown
 Go to default status screen
Keypad Access Security
This feature prevents accidental or unauthorized changes to settings from the SC100 keypad.
► To use DCTools to enable/disable keypad access
 In DCTools go to Communications.
 Set UI Access to:
 Unprotected - keypad access is allowed, or
 Protected - keypad access is denied (can be temporarily over-ridden, see below).
► To temporarily enable keypad access at the SC100 when access is set to Protected
 Press Up and Down keys together for 5 seconds.
 Keypad access is now temporarily enabled. Keypad access control reverts back to Protected
mode after the display goes back to the Summary screen.
Display Settings
► To change the display contrast
 Use the keypad to go to Menu > Configuration > Controller > Edit > Contrast.
► To test the LCD
 Use the keypad to go to Menu > Controls > Screen Test > Start.
 Press to stop the screen test.
► To change the display orientation (horizontal/vertical)
 Use the keypad to go to Menu > Configuration > Controller > Edit > Display.
Display Time-out
If there is no keypad activity for 2 minutes the display will go back to the default Status Screen.