Eaton SC100 - Rectifiers

SC100 Handbook
22
Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
Rectifiers
The SC100 registers all rectifier modules as they are inserted into the dc power system.
Information
The following information is available from rectifiers.
Parameter
Description
Where to find:
Software Version
Version of rectifier embedded software.
SC100: Menu > Identity >
Rectifier Identity
DCTools: Configuration >
RXP
Serial Number
(S/N)
Rectifier serial number.
SC100: Menu > Identity >
Rectifier Identity
DCTools: Rectifiers
Power
Rectifier output power as a percentage of Max. Power
Limit.
State
Registered - communicating with the SC100.
Un-registered - there is a rectifier compatibility or
communications problem.
DCTools: Rectifiers
AC Voltage
The ac voltage measured by the rectifier.
Voltage
Rectifier's dc output voltage. This is the Float Voltage
adjusted by any the voltage control processes such as
Temperature Compensation, Active Voltage Control,
and so on. See further details on page 14.
Current
Rectifier's output current.
Heatsink Temp
The measured rectifier heatsink temperature.
Max Power Limit
Rectifier's maximum output power (factory set).
Max Current Limit
The maximum dc current limit value of the rectifier.
 Adjust Rectifier Current Limit to set a lower
operating current limit.
Max AC Current
Limit
The maximum ac current limit value of the rectifier.
 Adjust Rectifier AC Current Limit to set a
lower operating current limit.
Status
Information about rectifier alarms.