Eaton SC100 - Specifications; SC100 system controller; IOBGP-00, -01 I;O Board

Appendix A
Specifications


Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
61
A p p e n d i x A
Specifications
SC100 system controller
Communications
RS232
Interface: RS232 (DTE)
Connector: DB9M
External modem options
Type: PSTN or GSM
Operation: Dial in/Dial out
on alarm
IOBGP-00, -01 I/O Board
The following specifications apply to a single IOBGP-00, -01 I/O board connected to the SC100
system controller.
Digital Outputs/Alarm Relays (IOBGP)
Number of Digital Outputs/Relays
6*
Contact Arrangement
One changeover contact per relay
Contact Rating
0.1A @ 60V dc maximum
Connectors
Screwless terminal blocks
Wire Size
0.5 - 2.0mm
2
[20 - 14 AWG]
Isolation
Relay connections are isolated to 500V dc from all
other circuitry, earth and system common.
 * Digital Output 6 is also used as the Monitor Fail alarm relay. It will de-energize if the I/O board
loses power or loses communication with the SC100.
Digital Inputs (IOBGP)
Number of Digital Inputs
6
Connectors
Screwless terminal blocks
Wire Size
0.5 - 2.0mm
2
[20 - 14 AWG]
Input Types
Voltage-free switch or relay contacts only
Input Range
Live Bus to Live Bus + 5V
Input Common
Same bus as used for current shunts (Live bus is
standard)
Input Protection
Protected against damage from short circuit to live
or common bus