SC100 Handbook
Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
► To connect a PC/laptop to the SC100:
1 Download the latest version of DCTools from: dcpower.eaton.com/downloads.
2 Install DCTools on the PC/laptop.
3 Connect a null-modem cable from the COM1 RS232 port on the PC/laptop to the RS232
connector on the SC100.
Ensure the cable is secured so that no force is applied to the RS232 connector as this may
damage the connector.
If COM1 port is not available or for more details see Direct RS232 Communications on page
48.
4 Start DCTools to open the Connection List. Check the box for the COM1 connection.
5 DCTools will now connect to the SC100.
If connection is unsuccessful refer to DCTools help (press F1) or Troubleshooting on page 56.
6 For details of the SC100 control and monitoring functions available via DCTools see System
Operation on page 13.
For help using DCTools press F1.
To Next Page
Loading...
