Eaton SC100 - Page 56

SC100 Handbook
50
Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
4 If the SC100 is to report alarms to PowerManagerII then click on + to expand
PowerManager Callback. Configure the following settings:
Alarm Report:
Select the type of event(s) that will initiate the dial-out
process.
Report Maximum Retries:
Set to the number of times the SC100 is to try to connect
with a remote modem, if the first attempt fails.
After this number of retries the SC100 will try the next
number in the Dial Out Numbers table.
 Dialing will stop if none of the numbers in the Dial
Out Number Table connect.
Report Retry Interval:
Set to the required interval between retries.
Dial Out Number(s):
Type the telephone number(s) to be called.
 Consult the modem documentation for appropriate
dial modifiers.
DCTools or PowerManagerII Communications Setup
► To connect to the SC100 with DCTools or PowerManagerII:
1 If not already installed, install the PC modem (hardware and software) according to the
manufacturer's instructions.
2 Install DCTools/PowerManagerII on the PC/laptop.
3 Double-click the DCTools/PowerManagerII icon to open the Connection Manager window.
4 Go to Connection > New to open a new connection dialog box.
5 Enter:
Connection Name:
<as required>
Comms Enabled:
True
Protocol:
S3P
Connect Using:
Select the COM port used by the modem (if external) or the
modem name.
S3P Address:
0 (0 = Broadcast, 1-65279 = individual address)
Phone Number:
The number of the PSTN line used by the modem.
Modem Logon:
Clear if a logon script is not required for the modem.
Select if a logon script is required. Click Logon Script to define.
For more details, see DCTools/PowerManagerII online help
(press F1).