Eaton SC100 - Page 60

SC100 Handbook
54
Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
► To clear or change a Write Access Password
1 Connect to the SC100 with DCTools (see details on page 48).
2 Go to Configuration > Communications
3 Type a new password into the Write Access Password field or leave the field blank for no
password control.
4 Click the Apply Changes button.
5 DCTools only: Type the old password.
► To clear a Write Access Password from the SC100
1 Use SC100 keypad to go to Menu > Configuration > Controller > Edit > Serial Port Access.
2 Select Clear.
 The password is now permanently cleared. If required, reset the password with DCTools.