Eaton Scantronic i-on10 - Page 29

Detectors/Devices Menu
Page 29
Attributes
Table 5 shows the zone attributes and the zone types they apply to. You can assign more
than one attribute to a zone. The display shows only the available attributes for the zone
type you select.
Table 5: Zone attributes available for zone types
Zone Attributes
Chime1
Chime2
Soak Test
Double Knock
Reset
Part Set B
Part Set C
Part Set D
Omittable
Force Set Omit
Inverted
Linked Zone
Extended Entry Time
Double Doors
Force Set
Zone Type
Not Used
Hold Up Alarm
Y
Fire Alarm
Y
Normal Alarm
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
24 Hour Alarm
Y
Y
Y
Y
Y
Y
Final Exit
Y
Y
Y
Y
Y
Y
Y
Y
Y
Entry Route
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Technical Alarm
Y
Y
Y
Y
Y
Y
Y
Key Switch Moment.
Y
Y
Key Switch Latched
Y
Y
Tamper
Y
Y
Y
Y
Y
Y
Y
HUD Fault
Y
Y
Y
Log Only
Y
Y
Y
Y
Exit Terminate
Y
Y
Y
Lock Set
Y
Security
Y
Tamper Return
Y
Y
Y
Y
Y
Y
Chime1 and Chime2
When enabled, the system gives a non-alarm chime when the zone is triggered. For
all but Exit Terminate zones, the chime operates only when the system is unset. For
Exit Terminate, the chime operates when the system is set or unset.
Chime1 and Chime 2 have different tones, and can be used to distinguish zones.
Soak Test
Use this zone attribute if you want to place under long term test a detector that you
suspect is giving false alarms. Zones with this attribute are disabled for 14 days after
you return the control unit to user/unset mode. If the zone remains inactive for the
whole fourteen days then after midnight on the 14th day, the control unit returns the
zone to normal use.
If the zone is activated during those 14 days while the system is set, the control unit
logs the event as a “Soak Fail Znn Alm” (nn is the zone number) without sounding
any sirens or starting communications. The control unit also lights the red LEDs
around the navigation key on the keypad to alert the user when they unset the
system. An installer must key in their access code to reset the alert.