15
OVERLOAD INDICATOR LIGHT (RED)
The overload indicator light (1) comes on when an overload of a
connected electrical device is detected, the inverter control unit
overheats, or the AC output voltage rises. Then, the AC protector will
trip, stopping power generation in order to protect the generator and
any connected electric devices. The AC pilot light (Green) will go o
and the overload indicator light (Red) will stay on, but the engine will
not stop running.
When the overload indicator light comes on and power generation
stops, proceed as follows:
1. Turn o any connected electric devices and stop the engine.
2. Reduce the total wattage of connected electric devices within the
rated output.
3. Check for blockages in the cooling air inlet and around the control
unit. If any blockages are found, remove them.
4. After checking, restart the engine.
TIP: The overload indicator light may come on for a few seconds at
rst when using electric devices that require a large starting current,
such as a compressor or a submergible pump. This is normal and
should not be treated as a malfunction.
AC POWER INDICATOR (GREEN)
The AC power indicator (1) comes on when the engine starts and
produces power.
CONTROL PANEL FUNCTION
To Next Page
Loading...
Need help?
General
