16
DC PROTECTOR
The DC protector turns to “OFF” (2) automatically when the electric
device connected to the generator is operated above rated ow. To
use this equipment again, turn on DC protector by pressing its button
to “ON” (1)
(1) “ON”
Outputting direct current.
(2) “OFF”
Not outputting direct current.
CAUTION
• Reduce the load of the connected electric device below the
specied rated output of the generator if the DC protector turns
o. If the DC protector turns o again, stop using the device
immediately and consult your local dealer.
ENGINE SMART CONTROL (ESC)
(1) “ON”
When the ESC switch is turned to “ON”, the
economy control unit controls the engine speed
according to the connected load. This results in
better fuel economy and reduced noise output.
(2) “OFF”
When the ESC switch is turned to“OFF”, the
engine runs at the rated
r/min(4500r/min) regardless of whether a load is connected or not.
TIP: The ESC must be turned to“OFF”when using electric devices
that require a large starting current, such as a compressor of a
submersible pump.
CONTROL PANEL FUNCTION
To Next Page
Loading...
Need help?
General
