35
Long term storage of your machine will require some preventive
procedures to guard against deterioration.
DRAIN THE FUEL
1. Turn the 3 in 1 switch to “OFF” (1) .
2. Remove the fuel tank cap and then remove the lter. Extract the
fuel from the fuel tank into an approved gasoline container. Then,
reinstall the fuel tank cap.
WARNING
• Fuel is highly ammable and poisonous. Check “SAFETY
INFORMATION” (page 6) carefully.
NOTICE
• Immediately wipe o spilled fuel with a clean, dry, and soft cloth as
fuel may deteriorate painted surfaces or plastic parts.
3. Start the engine (See Page 19) and leave it running until it stops.
The engine stops in approx. 20 minutes by running out of fuel.
TIP: Do not connect any electrical devices. (unloaded operation)
Duration of the running engine depends on the amount of the fuel left
in the tank.
4. Remove the screws, and then remove the cover.
5. Drain the fuel from the carburetor by loosening the drain screw on
the carburetor oat chamber.
6. Turn the 3 in 1 switch to “OFF”.
7. Tighten the drain screw.
8. Install the cover and tighten the screws.
STORAGE
To Next Page
Loading...
Need help?
General
