20
NOTE: Recommended oil
may vary due to ambient air
temperature. see oil graphic
for more information.
Recommended engine oil:
SAE SJ 10W-30
Recommended engine oil grade:
API Service SE type or higher
Engine oil quantity: 0.5 L
PRE-OPERATION CHECK
WARNING
• If any item in the Pre-operation check is not working properly, have
it inspected and repaired before operating the generator.
• The condition of a generator is the owner’s responsibility. Vital
components can start to deteriorate quickly and unexpectedly,
even if the generator remains unused for a period of time.
PREPARATION
The generator has been shipped without engine oil. Do not start the engine till
fill with the sufficient engine oil.
1. Place the generator on a level surface.
2. Screw the oil service door knob to "OPEN" and remove the oil service door.
3. Screw-out the oil plug, then screw-in sealing plug into the pouring orifice,
and use the funnel to add the specified amount of oil.
4. Screw the oil plug, installed oil service door and keep the knob to "CLOSE".
4.2 Engine oil
Recommended engine oil: SAE SJ 15W-40
Recommended engine oil grade: API Service SE type or higher
Engine oil quantity: 0.6 L
Lubricating oil pipe
Oil service door
Oil plug
20
32°F
0°C
-20 0-40 40 60 80 100 122
-10-30 -20-40 10 20 30 40 122
NOTICE
Always check the level of the engine oil prior to
starting the generator.
• Failure to do so could cause the engine to seize if the oil is low or
empty.
High Mark
Low Mark
Operating Range
To Next Page
Loading...
Need help?
General
