Eclipse CD8051 - Page 32

Basic operation
32
[FUNC] button
[ BND ] button
[SOURCE] button
 Switching Non-Fader modes
1. Press the [FUNC] button.
2. Press the [ BND ] button repeatedly until
[PHASE] appears on the screen.
3. Press the [SOURCE] button to switch NORMAL
/REVERSE.
4. Press the [FUNC] button.
Pressing the button will cancel Function mode.
 Disabling the guide tone feature (for button
operation)
The receiver is set at the factory to emit a beep tone in
response to button operation. The guide tone feature may
be disabled in the following procedure:
1. Press the [FUNC] button.
2. Press the [ BND ] button repeatedly until the
[BEEP ON] display appears on the screen.
3. Press the [SOURCE] button to switch to [BEEP
OFF].
4. Press the [FUNC] button again.