INSTALLING THE EMS Si
There are 5 steps to install the ecobee EMS Si:
Step 1. Power O HVAC Equipment
Step 2. Remove Existing Thermostat
Step 3. Install the EMS Si
Step 4. Connect the Wiring
Step 5. Power On HVAC Equipment
Step 1. Power O HVAC Equipment
Before disconnecting the existing thermostat, or installing the
EMS Si, disconnect the power to the heating and air conditioning
equipment.
Step 2. Remove Existing Thermostat
Disconnect the wires to the existing thermostat and remove
it from the wall (if you are installing the EMS Si in the same
location).
Step 3. Install the EMS Si
The ideal location for the thermostat is approximately 5 ft (1.5 m)
above oor level in the main living area.
Do not install the thermostat:
Close to sources of heat such as incandescent lights
Near supply heating/cooling sources
In direct sunlight
On exterior, non-insulated or poorly insulated walls
In the kitchen or other areas of potentially high heat and/or
humidity
7
To Next Page
Loading...
