Enable Heating/Cooling Alerts
Select No to disable alerts for heat/cool error
conditions. If disabled, alerts indicating that the
system failed to heat or cool will not be appear
in the screen, web portal, or emails.
List of Alerts
Below is a complete list of alerts. Depending
on your conguration, some of these may not
apply.
Furnace Air
Filter
UV Lamp
Low Temp Alert
High Temp Alert
Heat Not
Responding
Cool Not
Responding
Maintenance
Reminder
Auxiliary Heat Run
Time
Auxiliary Outdoor
Temperature
Furnace lter needs to be
cleaned or changed.
UV lamp needs to be changed.
Temperature in the home is too
low.
Temperature in the home is too
high.
The system has failed to heat
the home.
The system has failed to cool the
home.
HVAC system due for regular
maintenance.
Auxiliary heat source is running
too often.
Your EMS Si auxiliary heat has
been called to run when the
outdoor temperature exceeds
the programmed set point.
33
To Next Page
Loading...
