Ecobee EMS Si - Wifi

Duty Cycle This option allows you to
program the maximum amount of time the
system will run during a 1 hour period. For
example, if you select 30%, the air conditioner
will run for a maximum of 18 (0.3 x 60)
minutes regardless of whether the set point
has been met. 0% essentially turns the system
o, whereas 100% runs the system at full
capacity.
WiFi
The EMS Si supports WiFi 802.11 b/g/n. Use the
Advanced Conguration option in the WiFi
menu to congure your network parameters.
Choose the network from the list or manually
add a new one (i.e. if your network does not
broadcast its SSID).
You will then be able to view and congure the
following network parameters:
DHCP (select Disabled to use a static IP
Address; if unsure, leave DHCP Enabled)
SSID
Encryption (WEP, WEP128, WPA, or WPA2)
Password (if encryption is used)
WiFi Channel
IP Address and IP Subnet
Gateway
Primary and Secondary DNS
If you need to specify your EMS Si’s MAC address
in your router’s conguration, you can obtain it
from the About menu.
To congure WiFi
manually:
From the Home screen,
press MENU.
Select WiFi.
Adjust the network options
for your home network.
52