Ecobee EMS Si - AUTOMATION; Setting Up the Sensor Inputs

Test Equipment
These options let you test the wiring and
connections of the devices connected to the
thermostat by turning them on or o.
The equipment will turn o when you exit the
menu.
Warning: Compressor protection and
minimum run-time features are not
enforced while in this mode.
Reset HVAC Equipment Settings
You can quickly restore all HVAC equipment
settings on the EMS Si back to their factory
defaults. Any user setting (not related to the
equipment installed) will remain unchanged.
If you need to reset the entire thermostat back
to its original factory default settings, including
user settings and registration, select Reset All
Settings instead.
Performing a Hardware Reset
In rare circumstances, static electricity or power
surges may interrupt the operation of the
thermostat, forcing a hardware reset.
To test the equipment:
From the Home screen,
press MENU.
Select Settings ▶
Installation Settings.
Select Test Equipment.
Select OK.
Test the equipment
connected to the
thermostat by turning each
component on and o.
!
To reset the EMS Si:
From the Home screen,
press MENU.
Select Settings ▶ Reset.
Select HVAC Equipment
Settings.
Select Yes.
29