9
Step 4. Connect the Wiring
You need to use low-voltage cable to connect the thermostat to the HVAC
equipment. Check the wiring diagrams on pages 8 to 17 for the number of
wires required.
Note: There is a factory installed jumper between R/H and R/C. Ensure any
unused wires do not have exposed bare copper conductors.
To connect the thermostat to the equipment:
1. Connect the wires as shown in the wiring diagrams.
2. Attach the EMS Si to the backplate. Ensure that the pins on the
thermostat align with the terminal block on the backplate.
Wiring Diagrams
The following diagrams show how to connect the thermostat terminals to
various HVAC equipment.
To Next Page
Loading...
