Ecobee EMS Si - Reset HVAC Equipment Settings; Performing a Hardware Reset

Furnace
Allows you to enable and congure up to a
2-stage conventional heat source. If you have
selected a heat pump as your primary source,
this feature allows you to congure the 1st stage
of auxiliary heat connected to the system.
Furnace Type Allows you to congure the
type of furnace. This helps the thermostat
optimize its algorithms based on the type
of fuel and typical characteristics of the
chosen system. Choose the option that
best represents the type of heating system
installed.
Heat Fan Control Congures the furnace fan
to be controlled by the EMS Si or the HVAC
system during heat cycles. Normally the HVAC
system controls the fan during heat cycles.
Air Conditioner
Congures up to 2 stages of air conditioning. If
you require a second stage, you must enable the
Y2 relay.
24