EcoFlow 4000 - Preparation before Use; Add Fuel: Gasoline

EN
| 12
Preparation Before Use
Add Fuel: Gasoline
• Please read the Safety Guidelines carefully before refueling as fuel is inammable and toxic. Do
not overll the fuel tank, as fuel may expand and spill out when the fuel tank warms up. Be sure to
tightly close the fuel cap after refueling.
• Clean away any residual fuel with a clean and soft cloth after refueling to avoid damage to the
rubber shell.
• Please use unleaded fuel rather than leaded fuel which may severely damage the internal parts of
generator.
• Take off the fuel cap and ll up until the red indicator.
Add Fuel: LPG
• When the engine is running, do not place the LPG hose or the LPG cylinder in the exhaust passage
of the mufer.
• Do not allow children to tamper or play with the LPG cylinder or LPG hose.
• Use standard 20, 30, or 40-pound capacity LP cylinders with this generator.
• Use an approved LPG cylinder that is equipped with an OPD (Overll Prevention Device). Install
the LPG cylinder on a at surface, with the cylinder always in a upright position and the valve
resting on top of the cylinder.
• The gas cylinder should not be installed near any sources of ignition, and should not be exposed
to sunlight, rain, or dust.
• Close the cylinder valve during transportation and storage by disconnecting the cylinder and
covering it with a protective cap. If possible, a plastic protective cap is typically used. Keep the
cylinder far away from sources of ignition and ensure proper ventilation inside the vehicle.
• If there is a strong LPG smell, immediately close the cylinder valve, and use soapy water to wet all
the LPG hose ttings to check for leak. If bubbles appear or grow, it indicates a leak in the LPG
hose. Do not check for air leaks with an open ame, such as by lighting a cigarette. If you nd a
leak, contact a qualied technician for inspection.
• To add LPG, connect the LPG hose to the standard LPG cylinder for proper operation.
• Make sure that the inspection date on the LPG cylinder is within the scope of specied usage.
• The position of the cylinder must be rmly set to avoid excessive bending or twisting when the
LPG hose is connected.
Open the protective cap of the gasoline inlet. Refuel.
Fuel Filter Strainer
Red Indicator
1 2
Recommended fuel: unleaded gasoline
Fuel tank capacity: 1.59 gal. / 6.00 L
1. Make sure the LPG cylinder valve is in the closed position.
2. If you are using a new LPG cylinder, rst remove the plastic cap
located on top of the cylinder valve.
3. Connect the LPG hose to the LPG cylinder valve and tighten it with
the provided double-ended spanner.
4. Remove the dust cover from the LPG inlet of the generator.
5. Remove the protective rubber plug from the female connector of the
LPG hose.
6. Insert the female connector of the LPG hose into the LPG inlet and
push it until you hear a click, and move the outer ring of the female
connector forward.
Install the LPG Hose
Note: Close the LPG cylinder valve promptly when the generator shuts down. Do not place the LPG cylinder on the
side with the generator's muffler.
Thread: 5/8-18 UNF