EcoFlow 4000 - Page 19

EN
| 14
Checklist
• Please check the following components carefully each time before using the generator.
a. Check the fuel level (when using gasoline)
Take off the fuel cap and check the fuel level. Inject more fuel into the tank if the fuel level is too
low.
b. Check the LPG (when using LPG)
Open the LPG cylinder valve, and use soapy water to soak all the connections on the LPG hose to
check for leaks. If bubbles appear or bubbles grow, then this indicates a leak in the LPG hose. If
the leak is at a tting, then turn off the valve on the cylinder and tighten the tting. Open the valve
again and use soapy water to recheck the tting, then turn off the valve on the cylinder and tighten
the tting. If the leak continues, or if the leak is not at the tting, then stop using the generator and
contact customer support.
c. Check the engine oil level
• Make sure there are no engine oil leaks.
• Check the engine oil level. If the oil level is low, the engine oil alarm system may shut off the engine.
1. Unscrew the lid, take out the oil dipstick and wipe it clean.
2. Dip the oil dipstick into the oil filler to check the oil level.
3. Add the recommended amount of engine oil if the oil level is low.
4. Screw the oil dipstick and lid firmly shut.
d. Check whether the rechargeable battery is connected correctly
Open the protective cover of the Internal Rechargeable Battery port. Check whether the positive
and the negative wires of battery are connected correctly.
Check engine oil level
Proper Excessive Insufcient
Note: Malfunctions While Running
If any malfunction occurs while the generator is running, contact EcoFlow for further technical support.