Ecom j2kn pro - Page 30

Page 30 ecom-J2KN
pro
Graphic menu (<F1> for YES / <F4> for NO):
-Activation of graphic mode
Low power mode (<F1> for YES / <F4> for NO):
-Switching on / off the probe heating and the gas cooler at battery
operation
Probe heating (<F1> for YES / <F4> for NO):
-ON/OFF switch for probe heating for soot measurement
Language: English
-Info about language (3 languages selectable)
F1 Hotkey (Choose after pressing <OK>):
-Change the menu you get to after pressing <F1> in measured value
display
F4 Hotkey (Choose after pressing <OK>):
-Change the menu you get to after pressing <F4> in measured value
display
Eff.(C) (<F1> for YES / <F4> for NO):
-ON/OFF switch for calculation of efficiency with and without
condensation
RF-connect. only (Choose after pressing <OK>):
-Standard: no radio connection if control module is located
in basic module
-RF-connect. only: radio connection also if control module is
located in basic module
-Remote: without function
USB (selection after pressing <OK>):
-Adjustment of transfer speed (Cursor keys <Up/Down>) and
Protocol (Cursor keys <Right/Left>) for the USB interface
(connection USB):
-Protocol DAS = Protocol for the program DASNT
-Protocol Enhanced = Protocol for the program DAS5