BAT-I2 USER MANUAL
41
Chapter 3
fParallel Port Configuration
Scroll to this item and press <Enter> and view the following screen.
Parallel Port (Enabled)
This item allows you to enable or disable serial port.
Device Settings (IO=378h; IRQ=5)
This item shows the information of the device settings.
Change Settings (Auto)
Use this item to change device settings.
+/- : Change Opt.
Enter : Select
lk
mn
:Select Screen
:Select Item
Parallel Port Configuration
Parallel Port [Enabled]
Device Settings IO=378h; IRQ=5;
Change Settings [Auto]
Device Mode [Standard Parallel...]
F1:General Help
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
Enable or Disable Parallel
Port (LPT/LPTE)
Main Advanced Chipset M.I.B III Security Boot Exit
Device Mode (Standard Parallel...)
This item is used for Printer port mode selection, it can be set to Standard Parallel
Port Mode (SPP) or EPP Mode.
Press <Esc> to return to the Super IO Configuration page.
To Next Page
Loading...
Need help?
General
