ECS K7S6A - Page 35

29
LUSB2 Pin Assignment
Pin Signal Name Pin Signal Name
1
3
5
7
9
+5V
USB4–
USB4+
Ground
Ground
2
4
6
8
10
Ground
Empty
USB5+
USB5–
+5V
USB 2/3: USB panel connector
The mainboard has USB ports installed on the rear edge I/O port
array. However, some computer cases have a special module
that mounts USB ports at the front of the case. If you have this
kind of case, use auxiliary USB connector USB1 to connect the
front-mounted ports to the mainboard.
USB2 Pin Assignment
Pin Signal Name Pin Signal Name
1
3
5
7
9
VCC
USBP2–
USBP2+
Ground
Empty
2
4
6
8
10
VCC
USBP3–
USBP3+
Ground
OC#
USB3 Pin Assignment
Pin Signal Name Pin Signal Name
1
3
5
7
9
VCC
USBP4–
USBP4+
Ground
Empty
2
4
6
8
10
VCC
USBP5–
USBP5+
Ground
OC#
WOL1/WOM1: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with
the card to plug into the mainboard WOL1 connector. This en-
ables the Wake On LAN (WOL) feature. When your system is
in a power-saving mode, any LAN signal automatically re-
sumes the system. You must enable this item using the Power
Management page of the Setup Utility.