59
In the IRQ Resources submenu, if you change any of the IRQ
assignations to Legacy ISA, then that Interrupt Request Line
is reserved for a legacy ISA expansion card. Press <Esc> to
close the IRQ Resources submenu.
In the Memory Resources submenu, use the first item Re-
served Memory Base to set the start address of the memory
you want to reserve for the ISA expansion card. Use the sec-
ond item Reserved Memory Length to set the amount of
reserved memory. Press <Esc> to close the Memory Re-
sources submenu.
PCI/VGA Palette Snoop (Disabled)
This item is designed to overcome some problems that can be
caused by some non-standard VGA cards. This board in-
cludes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
Assign IRQ for VGA (Enabled)
Use this item to enable to assign an IRQ for the VGA. Please
note that some VGA does not work properly when an IRQ is
not assigned.
INT Pin 1-4 Assignment (Auto)
Identifies the interrupt request (IRQ) line assigned to a device
connected to the PCI interface of your system.
To Next Page
Loading...
