EDAN INSTRUMENTS SE-2003 Series

SE-2003&SE-2012 Series Holter System Recorder User Manual
- 38 -
Voltage dips, short
interruptions and
voltage variations
on power supply
input lines IEC/EN
61000-4-11
0 % U
T
; 0.5 cycle
At 0°, 45°, 90°,
135°, 180°, 225°,
270° and 315°
0 % U
T
; 1 cycle
and
70 % U
T
; 25/30
cycles )
Single phase: at
0°
0 % U
T
; 250/300
cycle
Not
applicable
Not applicable
NOTE: U
T
is the a.c. mains voltage prior to application of the test level.
Electromagnetic Immunity
Guidance and manufacture's declaration – electromagnetic immunity
Holter System Recorder is intended for use in the electromagnetic environment specified below.
The customer or the user of Holter System Recorder should assure that it is used in such an
environment.
Immunity test
IEC/EN 60601
test level
Compliance
level
Electromagnetic environment –
guidance
Conducted RF
IEC/EN
61000-4-6
3 Vrms
150 kHz ~ 80
MHz
6Vrms
c
in ISM
bands between
0.15 MHz and
80 MHz
3 Vrms
150 kHz to 80
MHz
6Vrms
c
in ISM
bands between
0.15 MHz and
80 MHz
Portable and mobile RF communications
equipment should be used no closer to any
part of the model recorder, including cables,
than the recommended separation distance
calculated from the equation applicable to
the frequency of the transmitter.
Recommended separation distance
Pd 2.1
150 kHz to 80 MHz
Radiated RF
IEC/EN
61000-4-3
10 V/m
80 MHz to
2.7GHz
10 V/m
80 MHz to
2.7GHz
Pd 2.1
80 MHz to 800 MHz