VE-H100B Veterinary Pulse Oximeter User Manual
- 13 -
NOTE:
1 This device has been tested and found to comply with
the limits for medical device in IEC/EN60601-1-2
(International standard for EMC testing of Medical
Electrical Equipment, third edition). These limits are
designed to provide reasonable protection against
harmful interference in a typical medical installation.
2 Sensor LED light emissions fall within Class 1 level,
according to IEC/EN 60825-1:2001. No special safety
precautions are required.
3 Normal operation means:
The oximeter is turned on;
A sensor is connected to the oximeter;
The sensor is applied to the patient;
The patient’s SpO
2
, Pulse rate are being reported;
No error conditions exist.
4 Wash the probe with clean water after disinfecting it to
remove any remaining solution. The probe can only be
reused after dried thoroughly.
5 Do not disinfect the probe with the water boiled.
6 Any residue should be removed from the probe before
being disinfected, and avoid contacting corrosive
solvent. Dipping the cable into alcohol or alkalescent
理邦保密文件
EDAN CONFIDENTIAL
To Next Page
Loading...
